You can control the heating using the [Wall Controller] or [Wall Pad] installed inside the room.
On the Wall Pad, tap “Heating” and wait for the screen to change.
You will then be able to toggle the system ON/OFF.
If the boiler controller (as shown in the photo) is in the OFF state,
press and hold the “Outing” button for about 3 seconds.
When the screen changes (as shown in the next image),
press the “Outing” button once again.
Heating will now be activated, and you can adjust the temperature using the UP / DOWN buttons. (See photo for reference)
While in [Heating] mode, press the [Temperature] button once to switch to [Hot Water] mode.
Tip: When first setting up hot water, setting the temperature to 60°C will provide faster access.
Hot water is supplied automatically 24/7, but it may take 2–3 minutes to start.
If hot water does not work even after 5 minutes, please contact the front desk.
Cooling can be adjusted using the remote control provided in the room.
Please switch to cooling mode and adjust settings as needed.
If the air conditioner continues to run even after turning it off, check if [Auto Dry] appears on the remote screen.
If not in use, please press the [Cancel] button to stop it.
The air conditioner filter is cleaned quarterly, but performance may vary depending on usage and environment.