[Busan Gijang] Home appliances

• You can watch Netflix and YouTube using your personal account.

• Please make sure to log out of your personal account before check-out.

• If the TV screen shows “No Signal”

  1. Check if the HDMI cable is properly connected to the correct input port.

  2. Turn off and on the set-top box behind the TV and wait about 5 minutes. (See Reference 1)

  3. Ensure the TV is set to “HDMI 1” input.

  4. Press the BTV power button and confirm that the indicator light is on and working properly. (See Reference 2)

  5. To switch to HDMI 1, use the “The ham” remote control. (See Reference 3)

• If Netflix or YouTube is not working

  1. Turn on the TV and press the Menu button on the long remote.

  2. Go to Settings → select Network.

  3. Change connection type to Wireless, then select Wi-Fi Settings.

  4. Find and connect to the Wi-Fi that starts with 0000_lecol.

• Use both BTV and The ham remotes:

  • BTV: For channel switching

  • The ham: For Netflix & YouTube

• Reference 1: Set-top box ON status

• Reference 2: Normal working status of the set-top box

• Reference 3: Remote control image

1. ① Pull out the water tank, open the rubber cap, and fill it with water.

2. ② Press the power button to turn it on and allow it to preheat.

3. ③ Press the button to release steam during use.

• ③ If you push the button downward, the steam will stay on continuously.

※ Steam is very hot – please use with caution to avoid burns.

• Inside the bathroom mirror cabinet of the master bedroom

• Hanging hook below the mirror shelf near the small bedroom entrance

1. Press the Power button.

2. Open the detergent compartment and add laundry detergent.

3. Close the compartment and turn the dial to your preferred course.

4. Press the Play button to start.

1. Press the Power button.

2. Turn the dial to select a course.

3. Press the Play button to start.

※ If the dryer is stopped mid-cycle, the door may not open due to internal heat.

※ Please wait 30–50 minutes for it to cool down before opening.

1. Press the Power button to turn it on (Press and hold for 1 second to turn off).

2. If using a styler sheet, place it inside the plastic case, then insert it into the sheet compartment.

3. Press the center button of the desired course – the light will turn on.

4. Press and hold the Start/Pause button for 1 second to begin or pause operation.